### Original Specification Ceramic Heater This ceramic heating cable is manufactured to match Anycubic's original specifications for the Kobra X hotend. It delivers stable and consistent heating performance, ensuring your filament reaches the optimal melting temperature for smooth extrusion. ### Precise Fit for Kobra X Hotend The 160mm cable length and standard 2-pin connector are designed specifically for the Kobra X toolhead board. Direct replacement for the factory heater with no wiring modification or soldering required. ### High Temperature Resistance Built with high quality ceramic heating plate and insulated wiring for reliable performance under high temperature conditions. Supports Kobra X's 300°C nozzle temperature capability. ### Restore Normal Hotend Temperature If your Kobra X fails to heat properly or shows temperature errors, a faulty heater is often the cause. Replace this component to restore stable temperature control and resume printing. ### Easy Plug and Play Installation The 2-pin standard connector plugs directly into the toolhead board. Simply disconnect the old heater cable and connect this replacement. No soldering, crimping, or wire stripping required