1.5M Extruder Extension Cable Assembly Kit for Creality CR-10 Smart Pro Ender-5 S1 3D Printer Hotend Upgrade Wiring Replacement

### Exclusive Compatibility For CR-10 Smart Pro & Ender-5 S1 Printer Models
Pre-matched terminal definition consistent with original factory circuit, direct plug replacement without pin rearrangement.
### Fixed 1.5M Total Length Meets Remote Extrusion Modification Demand
Enough reserved length for hotend lifting and frame refit, eliminate tension pull during full-range carriage movement.
### Full Outer Braided Mesh Wrap Improves Wear Resistance
Whole cable wrapped with dense woven sleeve to reduce friction damage from repeated carriage reciprocating travel.
### Built-in Intermediate Strain Relief Protect Inner Core Wire
Middle locking buckle restricts excessive bending range to avoid inner copper wire breakage from frequent swing.
### Pre-crimped Dual-end Complete Terminals For Plug-and-play Installation
Flat ribbon connector and small plastic terminals all pre-assembled, no extra soldering needed for DIY refit.
### Ideal Replacement To Solve Short Original Cable Restriction Issue
Fix limited moving stroke caused by stock short wire, support larger travel space after equipment modification.